Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLSE2.5 AP Radio Scan

I'm having trouble getting the WLSE to complete a AP Radio Scan. I have setup WDS with two APs (1220 & 350), ACS Server, and WLSE on the network. At least the Radio Scan doesn't fail anymore but it still doesn't work. Here is the log:

INFO: Executing the AP Radio Scan

INFO: Max Tx Power 100mW

INFO: Number of devices selected to participate in AP Scanning: 2

WARNING: Skipping device AP1230 because it has no applicable Radio Interfaces that can participate in Scanning.

INFO: Device AP350-TEST has 1 Radio Interface(s) that can participate in AP Radio Scanning

INFO: Delivering AP Scanning request to Radio Manager, number of Radio Interface(s) = 1

INFO: All interfaces temporarily configured to channel 6

INFO: Radio Scan measurement requests sent to all applicable interfaces

ERROR: Measurement request ACK timeout from WDS172.31.32.34/172.31.32.34

ERROR: Removing interface 00-0b-fd-06-8e-f8 from AP Radio Scan participation

ERROR: No APs are available to particpate - ending AP Scan.

INFO: Temporary channel and power settings disabled

INFO: Radio Scan measurements disabled, returning interfaces to original state

INFO: Radio Scan Complete!

INFO: Completed the execution of AP Scanning task.

Why won't the WLSE use the radio interface on the 1220? Why does it then remove the 350 radio interface from the scan? Any help would be appreciated. Thanks.

1 REPLY
Blue

Re: WLSE2.5 AP Radio Scan

AP350 does not support WDS, only 1200, so Scan will not work on 350s. As for 1200, WLSE 2.5 currently only supports "b" radios for any Radio Management features. If you have "G" radios, it will not work.

159
Views
0
Helpful
1
Replies