Step 1 Browse to the Wireless Services Summary page
Step 2 Click WDS to browse to the WDS/WNM Summary page.
Step 3 On the WDS/WNM Summary page, click Settings to browse to the WDS/WNM Settings page
Step 4 Check the Use this AP as Wireless Domain Services check box.
Step 5 In the Wireless Domain Services Priority field, enter a priority number from 1 to 255 to set the priority of this WDS candidate. The WDS access point candidate with the highest priority number becomes the acting WDS access point.
Step 6 (Optional) If you use a Wireless LAN Solutions Engine (WLSE) on your network, check the Configure Wireless Network Manager check box and enter the IP address of the WLSE device in the Wireless Network Manager IP Address field. The WDS access point collects radio measurement information from access points and client devices and sends the aggregated data to the WLSE device.
Step 7 Click Apply.
Step 8 Click Server Groups to browse to the WDS Server Groups page
Step 9 Create a group of servers to be used for 802.1x authentication for the infrastructure devices (access points) that use the WDS access point. Enter a group name in the Server Group Name field.
Step 10 Select the primary server from the Priority 1 drop-down menu. (If a server that you need to add to the group does not appear in the Priority drop-down menus, click Define Servers to browse to the Server Manager page. Configure the server there, and then return to the WDS Server Groups page.)
Step 11 (Optional) Select backup servers from the Priority 2 and 3 drop-down menus.
Step 12 Click Apply.
Step 13 Configure the list of servers to be used for 802.1x authentication for CCKM-enabled client devices. You can specify a separate list for clients using a certain type of authentication, such as EAP, LEAP, or MAC-based, or specify a list for client devices using any type of authentication. Enter a group name for the server or servers in the Server Group Name field.
Step 14 Select the primary server from the Priority 1 drop-down menu. (If a server that you need to add to the group does not appear in the Priority drop-down menus, click Define Servers to browse to the Server Manager page. Configure the server there, and then return to the WDS Server Groups page.)
Step 15 (Optional) Select backup servers from the Priority 2 and 3 drop-down menus.
Step 16 (Optional) Select Restrict SSIDs to limit use of the server group to client devices using specific SSIDs. Enter an SSID in the SSID field and click Add. To remove an SSID, highlight it in the SSID list and click Remove.
Step 17 Click Apply.
Step 18 Configure the WDS access point for EAP authentication
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...