We have Cisco 1231 and 1252 wireless APs working in Autonomous mode. I have been trying to implement WPA + AES with no luck. I understand AES should be used with WPA2 however, I have to get the WPA + AES working as this is being pushed by the company. We have sites in Europe using Cisco 4400 WLCs and AP1242 and they were able to get this to work.
Is this because of some restriction when the APs are working in Autonomous mode that you cannot implement WPA + AES?
I will really appreciate any help and suggestions on this.
WPA 2 and AES is supported on Cisco Aironet 1200 series radio modules with the part numbers AIR-RM21A and AIR-RM22A. However, the Cisco Aironet 1200 radio module with the part number AIR-RM20A does not support WPA 2. for the configuration guide follow the URL :
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...