Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WPA AP1200 and EAP-LEAP

I'm using AP1231G AP's that work fine with LEAP (obviously) and am trying to implement WPA as well. I'm using Funk's Odyssey server and supplicant. I authenticate but then the authentication seems to restart about every 3 to 4 seconds. I have exhausted Funk's support since the problem seems to occur with the ACU as well. I have duplicated this on a 1230B also.

Has anyone seen this symptom before? I have followed the WPA configuration overview doc 44721.

1 REPLY
New Member

Re: WPA AP1200 and EAP-LEAP

Hello,

I observe the same problem with the Funk Client, but I uses a 1230B AP.

I ask also Funk support, the answer was : have you right configured.

If I use WIN XP with INTEL ProSet, it works fine.

regards

Ulrich

288
Views
0
Helpful
1
Replies