I set the AP back to factory have my card authenticating using leap to my acs server. If I go back and in the key management and set it to mandatory and check WPA. In ACU I check WPA and try to reauthenticate nothing. I even turned on the debugg that TAC said to I see no messages what so every. I am at a loss right a the moment.
I can't really help with ACS as I am not familiar with it however, when configuring the AP using the GUI:
In Encryption Manager, make sure you use only the TKIP cipher. Also, select key 2 for transmit and clear the hex data.
In SSID Manager, select Open Authentication with EAP, and Network EAP. On the same screen, check Key Management as Mandatory and check WPA.
Provided you configured the AP to talk with the ACS server, it should work.
I also had problems setting things up in the beginning and had to resort to opening a TAC case. The Cisco engineer tested my setup in his lab and resolved my issue in very little time. You might try that as a last option.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...