I did WPA encryption using linksys access point with NETGEAR WG111v2 adapter.It worked fine.But now when i use aironet 1200 series access point,WPA encrytion is failing.I am using the same encryption algorithm and NETGEAR adapter WG111v2.I have pasted the debug message at the end.
Can anyone help me please?
Without encryption i am able to access aironet 1200 series access point from my pxa processor unit.Only if i enable WPA-PSK, it is failing.
With same configuration for radio interface, i just disabled WEP encryption and enabled ciphers with (TKIP+WEP128) and entered Encryption key 3 as transmit key.Then i gave Authenticated Key Management as optional and enabled WPA.Entered WPA pre-shared key.The same WEP key and WPA preshared key i entered in client and enabled WPA.Then it is not working.Authentication is failing.
Please let me know what kind of hardware/firmware information i have to provide you.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...