cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
308
Views
0
Helpful
1
Replies

WPA2 error

johnsonk1024
Level 1
Level 1

Hello,

I am trying to create a WLAN with WPA2 and AES for our WVoIP through WCS. Every time I try to apply the template to the controllers I receive the following error: "WPA2 Security Not Supported in this controller version". WCS is version 5.0.89 and the controllers are 4.2.99. Has anyone seen this before?

Thank you,

Kendall

1 Reply 1

Scott Fella
Hall of Fame
Hall of Fame

Might be due to your WCS being on version 5 and your WLC being on version 4.2. I know some say that WCS 5 is compatible with 4.2, it might be but some templates might not work like in your case. I was always told by TAC to keep the same version level. But I might be wrong....

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: