Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WPA2 not seen in WLC "show running-config" Why not???

Hi,

I'm running 4.1.185.0 on a WiSM.

From a factory-default config. I had to enter a few commands to get "show wlan 1" indicating WPA2, AES and Auth Key Management=802.1x

Two unexpected thigs:

1) The 2nd WLAN I created didn't need any further configuration than "wlan create 2 ..." and it already had WPA2, AES and Auth Key Management=802.1x. The 1st WLAN config seemed to have change the WLC WLAN security defaults, right?

2) When I do "show running-config" I see no reference to WPA, and none to AES. Isn't this command output meant to be in a format where you can paste it into a factory-default WLC & get what you saved in the text file (like IOS)?

Regards, MH

1 REPLY
Anonymous
N/A

Re: WPA2 not seen in WLC "show running-config" Why not???

In this case I would suggest you to create a wlan in a file ( copy , Paste the wlan configuration) and download it via TFTP.

133
Views
0
Helpful
1
Replies
CreatePlease to create content