I have a WRV200 router and I set up three SSID on it. In one of the SSIDs I disabled wireless isolation. But for some reason two wireless computers in the same SSID can not reach each other. If I put on computer on the wired network it can reach the other so it's not something with the computers.
In the WEB interface of WRV200 there is an error. If I set Wireless Isolation (within SSID): disabled then the isolation is enabled, so the computers can not see each other within the same SSID. If I set it enabled then it is disabled, so the computers can see each other.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...