Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Configuration Example - CLI and GUI Login Banner on ACS 5.4

     

     

    Introduction

    This document provides an example about latest feature of  ACS 5.4.  It gives you description on how to configure Login Banner (After Login  and Before login) on CLI and GUI interface of ACS 5.4.

    Requirements

    Ensure that you have configured ACS and can access the ACS through GUI as well through CLI access.

    Components Used

    The information in this document is based on these software and hardware versions:

    • ACS 5.4
    • ACS 1121

    The information in this document was created from the devices in a  specific lab environment. All of the devices used in this document  started with a cleared (default) configuration. If your network is live,  make sure that you understand the potential impact of any command.

    Conventions

    Refer to the Cisco Technical Tips Conventions for more information on document conventions.

    Configuration

    In this section, you are presented with the information to configure the features described in this document.

    Note

    Use the Command Lookup Tool (registered customers only) to obtain more information on the commands used in this section.

    For Before Login banner message:

    Step 1. Login to ACS GUI> Go to my workspace> click on login  banner > on the right hand side>Before login( configure the banner  message)

    banner2.png

    Step 2: For configuring banner message after the login>Login to  ACS GUI> Go to my workspace> click on login banner > on the  right hand side>After login( configure the banner message)

    afterlog.png

    Verify

    This is how it will appear on the ACS GUI: Before Login:

    beforelog.jpg

    After Login on ACS GUI

    afterlogin.jpg

    Before Login on CLI

    clibefore.png

    After Login on CLI

     

    Afterlogcli.jpg

    Note:

    You can only configure the banner for 250 characters. More than 250 characters are not allowed. You cannot configure separate banner for CLI and GUI.

    Reference

    User Guide for Cisco Secure Access Control System 5.4 - Understanding My Workspace

    Please post comments if there are any queries and rate if useful

    Version history
    Revision #:
    2 of 2
    Last update:
    ‎08-29-2017 03:11 AM
    Updated by:
     
    Labels (1)
    Contributors
    Comments
    Silver

    Hi Minakshi,

    Very Nice Document. Pretty helpful.

    Silver

    Thank you very much

    Minakshi