Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Configure the DHCP relay on an ASA/PIX over VPN

Introduction

In order to configure the DHCP relay on an ASA....below is the requirement :

This document uses this network setup:

  1. pix-asa-dhcp-relay-network-diag.gif

In this case, on the Relay Agent ASA2,in the crypto ACL , add the public IP on the ASA2 ---- to the DHCP server;
and on the ASA1, add the DHCP server to the relay Agent in the crypto ACL and on the Nat Exampt ACL.

Additionally ,  on the ASA2 , add these below commands :

dhcprelay server <DHCP Server Address> outside
dhcprelay enable inside
dhcprelay setroute inside
dhcprelay timeout 60

Version history
Revision #:
1 of 1
Last update:
‎11-29-2009 04:18 AM
Updated by:
 
Labels (1)