Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

DHCP relay fails when the static command is configured using the interface IP on the PIX 500 Series Firewall with software version 7.x

Core issue

This problem occurs due to the presence of the Cisco bug ID CSCei23290.

Resolution

In order to resolve this issue, remove the static command that matches the inside interface IP (the source of the Dynamic Host Control Protocol [DHCP] requests). For translations, use Port Address Translation (PAT) or Network Address Translation (NAT) instead of the static command.

An upgrade to PIX version 7.1.x also fixes this issue.

581
Views
0
Helpful
0
Comments