Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Question: IPSEC VPN - WRVS4400N to Cisco ASA 5510

Hello all,

I am in dire need of assistance with WRVS4400N Version V2.0.0.7.

I have been attempting for weeks to connect an IPSEC tunnel between a Cisco ASA 5510 Version 8.0(2) and a WRVS4400N . Phase one seems connect okay, where as phase two always give me the errors below. This as far as I have got, I tried disabling keep alive monitor, the device never attempted phase 2.  I have read endless documentation on both devices and tried almost every combination of setting that I am aware of. Any input would be greatly appreciated, the best case scenario answer would be detailed steps on how to setup the IPSEC VPN (linksys) & the site to site VPN (CISCO) as I cannot find any refrence material for this combination .

VPN ERROR

Thank you in advance,

Dan

Version history
Revision #:
1 of 1
Last update:
‎10-14-2009 10:18 AM
Updated by:
 
Labels (1)
Comments
New Member

Dear Dan,

After all your configuration just go to IPSEC rules & exempt ASA side host/network from Address Translation.