Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

The "no route to x.x.x.x from x.x.x.x" error message appears on the PIX Firewall with software version 6.x

Core issue

This error can occur due to the missing route between the source and destination network. During this time, traffic does not pass through the PIX Firewall.

Resolution

As a workaround, check whether these commands are configured in the PIX Firewall and if not, configure these commands:

  1. The route command:

    route if_name ip_address netmask gateway_ip [metric]

  2. The static command:

    static
    [(local_ifc,global_ifc)] {global_ip | interface} {local_ip [netmask mask] | access-list acl_name} [dns] [norandomseq] [max_conns [emb_limit]]

Refer to the Establishing Connectivity section of PIX Firewall and VPN Configuration Guide for more information.

302
Views
0
Helpful
0
Comments