Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2620XM - Cannot collect Inventory

I have a network of over 1000 devices all happy with inventory collection. However 2 devices are driving me to distraction they are both 2620XM devices.

Version details are:-

cisco 2620XM (MPC860P) processor (revision 0x300)

Processor board ID JAE0816DVPP (3121480657)

M860 processor: part number 5, mask 2

Running IOS (tm) C2600 Software (C2600-I-M), Version 12.3(1a), RELEASE SOFTWARE (fc1)

I have checked snmp details and can snmp walk from other nms (Openview) but cannot manage in CiscoWorks, I have collected configs so telnet is good. Tried to look at packages and I do have 2620XM RME installed. Please can anyone offer any advice?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: 2620XM - Cannot collect Inventory

Hi Steve.

Thanks for that information. I believe you're hitting bug CSCdx50192, which you can view through the bug toolkit. This isn't necessarily a Ciscoworks bug, but rather a bug with the ENTITY-MIB and how it's implemented in these devices.

The latest information I have in regards to this is:

CSCdx50192 - "Some of the objects in ENTITY-MIB are not getting

populated".

* This bug has been resolved in 12.3(4)T and later releases of code for the 2620XM.

4 REPLIES
Cisco Employee

Re: 2620XM - Cannot collect Inventory

Hi Steve.

What version of RME are you running, and when you run a "check device attributes", does everything pass? What doesn't?

-Joe

New Member

Re: 2620XM - Cannot collect Inventory

I am running LMS2.6

RME Version & Patch Level: 4.0.5

When I run device credential verification I get:-

Device Name

Read Community OK

Write Community OK

Telnet OK

Telnet Enable OK

I have collected the configs, but fails inventory.

Cisco Employee

Re: 2620XM - Cannot collect Inventory

Hi Steve.

Thanks for that information. I believe you're hitting bug CSCdx50192, which you can view through the bug toolkit. This isn't necessarily a Ciscoworks bug, but rather a bug with the ENTITY-MIB and how it's implemented in these devices.

The latest information I have in regards to this is:

CSCdx50192 - "Some of the objects in ENTITY-MIB are not getting

populated".

* This bug has been resolved in 12.3(4)T and later releases of code for the 2620XM.

New Member

Re: 2620XM - Cannot collect Inventory

Thank you

113
Views
0
Helpful
4
Replies