Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

3005 tp Pix Problem

Hi All..

Am trying to setup a remote site using a Pix506e on the remote end and a 3005 Concentrator at the headend. I am getting an error on the pix that says "VPN Peer: ISAKMP: No remote peer info for 12.109.169.12/500 - peer:0" That IP address is the 3005 and is listed in the crypto map set peer statement on the pix. debug shows that an IKS tunnel is created but not the IPSEC tunnel. I have a rapidly approcahing deadline so any thoughts are helpful.

TIA

Ron...

2 REPLIES
Cisco Employee

Re: 3005 tp Pix Problem

I guess first off make sure you've followed the sample config to the letter:

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_configuration_example09186a00800949d2.shtml

New Member

Re: 3005 tp Pix Problem

That was the example we had tried. Copied it exactly... still got the errors. Becuse of the deadline we were facing we moved to a different solution but thanks for your help. We'll be trying this configuration again at a later date.. Hopefully we'll have more luck then.

125
Views
0
Helpful
2
Replies