cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1097
Views
0
Helpful
1
Replies

3030 Concentrator Setup

slerwin
Level 1
Level 1

Just installed a 3030 concentrator and cannot ping the router on the public interface. I can ping everything on the private interface. I have added the default gateway for the public interface but cannot ping it and cannot ping the public interface from the router. The status on the interface is up.

1 Reply 1

gfullage
Cisco Employee
Cisco Employee

By default the Public interface has the public filter assigned to it, which should allow ICMP packets in and out. If you've played around with the filters or rules under Config - Policy Mgmt - Traffic Mgmt, you might have inadvertantly removed the ICMP rules from the Public filter.

Try removing the filter from the public interface and see if that allows you to ping. If so, then you need to add the ICMP In/Out rules to the Public filter.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card