Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

AnyConnect Clients and Lan-to-Lan IPSec Tunnels

Is there anyway to configure an ASA to make it possible for AnyConnect SSL clients to be able to traffic over IPSec tunnels to remote networks. The IPSec tunnels are configured on the outside interface, which is the same interface that the SSL client is connecting to. I know this is possible with the Cisco VPN client using IPSec, so I was hoping it would by possible with the AnyConnect client as well. I believe I have all the necessary statements in place to encrypt traffic from the AnyConnect client subnet to the remote networks on the other side of the IPSec tunnesls. I also have already prevent that traffic from getting nat'ed. I have configured split-tunneling, and it works perfectly for the subnets connected to the ASA, but I'm not able to traffic to the remote subnets over the IPSec tunnel. Show crypto ipsec sa shows that there is an sa established for the proper subnets, but it doesn't encrypt any traffic when I send traffic from the AnyConnect client to the remote subnets. Any ideas?

1 REPLY
New Member

Re: AnyConnect Clients and Lan-to-Lan IPSec Tunnels

The only thing I was missing was the following:

same-security-traffic permit intra-interface

I am now able to traffic to the remote networks from the SSL client over the IPSec tunnels.

408
Views
5
Helpful
1
Replies