Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ASA 5505 disable commands h323

Hi,

I have to disable the commands below:

policy-map type inspect h323 NO

parameters

policy-map type inspect h323 NORAS

parameters

policy-map global_policy

class inspection_default

  inspect h323 ras NORAS

Was told by a consultant to type no before inspect, but got the error messages below:

Result of the command: "no inspect h323 NORAS"

no inspect h323 NORAS

     ^

ERROR: % Invalid input detected at '^' marker.

Result of the command: "no inspect h323 ras NORAS"

no inspect h323 ras NORAS

     ^

ERROR: % Invalid input detected at '^' marker.

HELP!!!!!!!

Thank you,

mojorizn1

Everyone's tags (6)
2 REPLIES
Bronze

Re: ASA 5505 disable commands h323

Hi Bettyann.

sometimes when you mistype something or you are in the wrong config mode, you'll exit back to global config mode, which is not the right place.

you'll have to do it in this order (notice the prompt indicating the configuration mode/submode)

ASA(config)# policy-map global_policy
ASA(config-pmap)#  class inspection_default
ASA(config-pmap-c)# no   inspect h323 ras NORAS
ASA(config-pmap-c)#

Regards,

New Member

Re: ASA 5505 disable commands h323

That Works!

Thank you.

2817
Views
0
Helpful
2
Replies