Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ASA 5510 to connect Microsoft ISA

Dear Sir,

I would like to connect ASA 5510 8.0(3) to Microsoft ISA 2006 over IPSEC tunnel, but I have a problem.

When ASA try to estabilish the tunnel i got the log status is: MM_WAIT_MSG2

When ISA try to estabilish the tunnel i got the log status is: MM_WAIT_MSG3

And I monitor the Internet traffic outside of ISA and not got any packets from the CISCO over Internet. NOTHING that CISCO seems to be muted.

From ISA I can go to the ASA because I see the log, but the other side is nothing.

Can be the problem the heavy network traffic? Because I nmap the ISA UDP port 500 and that response only 6.03 sec.

1 REPLY

Re: ASA 5510 to connect Microsoft ISA

You need to provide the ASA configuration and the following debugs

debug crypto ipsec 127

debug crypto isakmp 127

debug crypto engine

Regards

Farrukh

245
Views
0
Helpful
1
Replies
CreatePlease to create content