Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ASA 5515 management interface

I started to configure a new ASA 5515 to replace an 5510.  When I attempted to remove the "management-only" command from the Management0/0 interface I was greeted with the following error:

"ERROR: It is not allowed to make changes to this option for management interface on this platform."

Does this mean we can't use the managment interface anymore on these newer ASAs?  I was planning on using that port when we bought it.  If this is the case, let this be a warning to whoever is counting the managment port as a 7th interface on the 5515!

  • Security Management
Everyone's tags (2)
2 REPLIES
New Member

Re: ASA 5515 management interface

Update: I just found out that you can't use the management interface for failover purposes either.     Argggggg.

"Management interface cannot be configured for failover on this platform."

Hall of Fame Super Silver

ASA 5515 management interface

That's correct.

The new X series platforms, while adding ports in their base configurations over their predecessors, limit you to using the management port for management.

4681
Views
0
Helpful
2
Replies
This widget could not be displayed.