Recently I was given a task on trying to configure VPN on the ASA 5505, but so far I have been unsuccessful. When i try to use the Cisco VPN Client Version 4x it gets to the authentication part asking for a username and password. When I use the Username and Password I set up on the ASA 5505 it tries to connect but ends up quiting.
This is the error that I recieve when it fails to connect
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...