I am adding devices to CSM3.2. All the devices is authenticating using ACS5.1 but I did not add CSM to ACS. I used the username and password from ACS 5.1 to access the devices and use telnet as the default protocol to discover the devices.
Of course, I entered the credential, primary credential only and I unchecked the Secondary credential whish is http and then click next, I am devices using the first option, adding devices from the network, and I am not using snmp. but then I cannot access/add the devices.
What might be the solution to this problem? Please advise.
CSM is like a regular user. So, use the credentials (in ACL or LOCAL) you use when you try to log-in with CLI.
Though, pay attention to how CSM is logging into the device. By default it will try http. So, make sure you are putting the right credentials for the method CSM is using to add the device. Before you add the device you can also test connectivity to make sure CSM can log into it.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...