Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Security Manager configuration for ASA IPv6 standby

Hi,

is it possible to configure failover ipv6 adresses for ASA in CSM 4.x ?

the ipv6 adresses on standby ASA go to state DUPLICATE if there is the standby option missing ->

ipv6 address 2001:1111:2222::1/64 standby 2001:1111:2222::2/64

and if ipv6 DAD is disabled the ipv6 adress failover event on both the primary and secondary ASA goto DUPLICATE which results in stopping traffic forwarding.

(yes there are flexconfigs - is a bit worthless for a large number of interfaces)

 

best regards

1 REPLY
New Member

this is a new problem in 9.1

this is a new problem in 9.1.5

84
Views
0
Helpful
1
Replies
CreatePlease login to create content