Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco SNMP Trap

Dear folks,

Is there any document the suggests/recommends what traps should be enabled for fault management of Cisco devices?

I do not seem to be able to find the following MIB files:

CISCO-ITP-DSMR-SMPP

CISCO-ITP-DSMR-UCP

CISCO-ITP-DSMR

Any one know where I can find these files?

Thanks in advance,

T Dang

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: Cisco SNMP Trap

Hi T Dang,

That's a very broad question as far as what traps should be enabled for fault management. I think a good place for you to start would be here:

http://www.cisco.com/en/US/tech/tk648/tk362/tk605/tsd_technology_support_sub-protocol_home.html

You'll see that much of this is dependent on the type of devices you're monitoring, the statistics you're interested in gathering, and other factors. Hopefully, that link is helpful.

As for the other part of your question regarding these MIB files:

CISCO-ITP-DSMR-SMPP

CISCO-ITP-DSMR-UCP

CISCO-ITP-DSMR

I've done some research into these, and it looks like these MIB files were removed as DSMR is no longer supported feature on ITP...so those MIBs are obsolete.

If you have a SGM, you still might be able to find them though. Either dowloaded from the from the sgm web page:

http://:1774/

there is a link at the bottom of the page.

Or The Zip file mibs.zip, located at the top of the SGM CD Image, contains these MIBs.

HTH,

-Joe

2 REPLIES
Cisco Employee

Re: Cisco SNMP Trap

Hi T Dang,

That's a very broad question as far as what traps should be enabled for fault management. I think a good place for you to start would be here:

http://www.cisco.com/en/US/tech/tk648/tk362/tk605/tsd_technology_support_sub-protocol_home.html

You'll see that much of this is dependent on the type of devices you're monitoring, the statistics you're interested in gathering, and other factors. Hopefully, that link is helpful.

As for the other part of your question regarding these MIB files:

CISCO-ITP-DSMR-SMPP

CISCO-ITP-DSMR-UCP

CISCO-ITP-DSMR

I've done some research into these, and it looks like these MIB files were removed as DSMR is no longer supported feature on ITP...so those MIBs are obsolete.

If you have a SGM, you still might be able to find them though. Either dowloaded from the from the sgm web page:

http://:1774/

there is a link at the bottom of the page.

Or The Zip file mibs.zip, located at the top of the SGM CD Image, contains these MIBs.

HTH,

-Joe

New Member

Re: Cisco SNMP Trap

Thanks Joe.

T Dang

398
Views
0
Helpful
2
Replies
CreatePlease login to create content