Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CiscoWorks adding PIX

I have a few sites that have the pix firewall in a DMZ and I need to know if it is possible to use CiscoWorks to monitor and back up all of the devices including the pix's in DMZ.

Would it be as simple as adding the SNMP and loopback address?

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: CiscoWorks adding PIX

You can add the PIX via an snmp accessible address and then use the read-only community string in the device credentials when adding the device into

RME 3.5 or the DCR (LMS 2.5)

You also need to make a device configuration to allow snmp access:

a. snmp-server host where x.x.x.x is the IP Address of CW2K server and interface is where the CW2K server packets will come through

b. snmp-server community

2 REPLIES
Cisco Employee

Re: CiscoWorks adding PIX

You can add the PIX via an snmp accessible address and then use the read-only community string in the device credentials when adding the device into

RME 3.5 or the DCR (LMS 2.5)

You also need to make a device configuration to allow snmp access:

a. snmp-server host where x.x.x.x is the IP Address of CW2K server and interface is where the CW2K server packets will come through

b. snmp-server community

New Member

Re: CiscoWorks adding PIX

Excellent Daivd your recommendation worked out great.

238
Views
0
Helpful
2
Replies
CreatePlease to create content