Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ciscoworks LMS 2.2 layer 2 trace problem

i have a 3745 (seed device) connected to a 2611xm via a 2950 switch but the ani server cannot discover the 2611xm or even properly recognize the 2950 switch. i have configured the required snmp parameters and cdp is enabled on all devices. i can also ping the 2950 and 2611xm from the ciscoworks server.

do i need special configs on the 2950 for the ani server to discover the 2611xm router?

1 REPLY
Hall of Fame Super Silver

Re: ciscoworks LMS 2.2 layer 2 trace problem

To troubleshoot, go into the respective devices and execute "show cdp neighbors" commands.

If the devices all see each other as neighbors, the problem is in CW's interaction with the devices. If that is the case, make sure each device's credentials are allowing CW to correctly query it.

If not, then fix the cdp interaction on the devices and rediscover and then recheck CW's network view.

Hope this helps. Please rate helpful posts.

159
Views
0
Helpful
1
Replies
CreatePlease login to create content