CiscoWorks Vs TACACS+ ??!! sw management problem--Pls help me out
I have a query to ask on the software image management.Please help me out.
There are many cisco devices in my client place, but only one device is creating a problem.
it is 2950 catalyst switch. CiscoWorks is complaining that 'it has no image to import', when we run a job to fetch the image from the switch. but it has image under root directory of Flash. After going through RME troublshooting and tips , I came to know that the connection protocol is telnet and ssh. Then I add the following commands in TACACS+ (to allow CW2K) user which is a centralized authentication system for all user including CiscoWorks.
Re: CiscoWorks Vs TACACS+ ??!! sw management problem--Pls help m
Thanks mmellet. i resolved this problem by adding a command 'terminal no monitor' in the TACACS. In the ACS-failed attempts, i have seen that this command was blocked by TACACS+. This is not documented in Cisco. Cisco needs to improve upon this documentation.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...