As I knew when we discover devices, it will discover all the devices config and overide the previous copy in CSM DB. Can we SELECTIVELY choose only one device to be discovered ? Otherwise afer discovered we need to re-deploy all again.
Reason is 1 out of 4 firewall managed by CSM. The user access direct to firewall and perform configuration change directly at firewall. Therefore the CSM DB is not in sync with firewall. I just want to discover that unit of firewall.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...