After i pre-configure the ASA 5505 (8.4.3 / 8.4.2 or 8.3.2) with a PPPoE configuration everything is fine. The ASA receive the dyn. IP Address from the Provider. if i deploy the a configuration with the CSM/AUS, the ASA lost the PPPoE Session (Dyn. IP Address) and didn't restart to Dial-In.
There are also no output, if i start "debug pppoe event | error | packet 255".
After restart the ASA connect without any issues to the provider and receive and IP Address, until to the next deployment.
Has everyone the same issues? Any workarounds or ideas based on this problem?
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...