This is my first time installing the CSM. I am reading the procedures and guidelines. As the procedure of course is to install the CSM software. After installing the CSM software, I think the next procedure is to add the devices to be managed..? I have a CISCO MARS devices and I found out tha it could be integrated to MARS. Is it good idea to integrated the CSM to MARS?. Adding devices to CSM needs snmp ro/rw? I already have snmp ro/rw configured in my routers and switches that is being used by my MARS, is it possible to reuse that?
The next step after installation is to add the devices FW's/IOS routers/Switches etc. It is really a good thing to integrate MARS and CSM so you can correlate events on MARS with the config on the CSM. CSM by default connects to devices using "https" protocol so make sure https is enabled on devices. I have attached a PPT slide which tells you the other protocols you can use.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...