How does one add the custom graphics to the VPN Client?
I'm using the Install Shield Install, because the .msi one looked too hard to customize with transforms and such.
I have an oem.ini file, and I've changed the settings in that OK (like program name, and install path), but I can't figure out how to replace any of the graphics? The Documentation only says:
"Table 5-2 lists the GUI image (portable network graphic) files that the VPN Client uses. If you want to replace any of them with your own image files, you must name your image files exactly as shown in the list; otherwise, the VPN Client GUI does not recognize them."
But it never says WHERE to put these files. Also it never says if they need to be noted in the oem.ini file, and if they do I don't know the syntax to use!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...