Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

dfm 2.0.4 config retreival

How can I configure DFM 2.0.4 to collect config from device when config changes, immidiatly?

thanks!

3 REPLIES
Cisco Employee

Re: dfm 2.0.4 config retreival

Hi,

DFM actually does not collect configs from devices, it is used for events and alerts.

You would have to use RME portion of LMS for config collection. With this you can setup RME to collect config changes immediately if you are sending a config change syslog message to CiscoWorks. This would trigger RME to then go out and pull the config.

HTH

New Member

Re: dfm 2.0.4 config retreival

:-)) syntax error, I taught on RME. Where exactly is this setting?

thanks!

Cisco Employee

Re: dfm 2.0.4 config retreival

Actually in RME 4.0 is automatic by default.

If RME receives a syslog message from a managed device, then it will perform a configuration archive to get the latest up to date configuration.

As a test, you can insert a new loopback interface and then in RME GUI, Config Mgmt > Archive Mgmt > Out-of-Sync Summary to check the devices who have different startup from running configuration.

You will see there the device with the new loopback interface.

106
Views
0
Helpful
3
Replies