I have a classic EZVPN setup with a VPN3020 as the server and about 20 or so 831 clients. My problem is that you can't issue the qos pre-classify command under an EZVPN profile. In this case how would I prioritize traffic witin the EZVPN tunnel?
Iam not sure about EZVPN but in normal IPSec tunnels, the ToS byte on the IP packet gets copied onto the new header being formed so the best way to do QoS is to mark the ToS byte on the previous i/f or Router and match the ToS on the Queuing i/f.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...