dear support
i have a problem recently, i have a 2811 router, there are several EIGRP VPN tunnel setup on it, recently i found this router running high CPU utilization, it almost reach 80 percent at the most day busy time, when i try to find what process causing that after " show proc cpu", the summarize number not such high, it estimate not more than 20 percent. i know in old Cisco IOS there is a command "show platform health", but seem this not exist in 2800 serials any more.
so my question is what can i do next step to finding out what is causing high CPU usage, so that i can decide if the router need to be upgraded.
thanks very much