Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

How do I set up an bonded network interface on an M series SMA?

On our C series ESA Ironports, we have set up a bonded interface using interfaceconfig on the CLI so that they can have a redundant failover interface.

However our new M series SMA (running AsyncOS8.0.1) do not appear to have the bond option in the interfaceconfig, only VLANs.  I cannot work out how to define a failover bond on these devices, which is necessary as we have a pair of redundant switches in our datacentre.

Is there a way to achieve this?  I can't find anything in the documentation about it, though surely it should work if it works on the C series?

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Hi, The NIC Pairing feature

Hi,

 

The NIC Pairing feature is not present on the SMA at the moment. Here is the feature request for it: CSCzv93379

 

 

Do rate if helpful

 

Regards,

Kush

1 REPLY
Bronze

Hi, The NIC Pairing feature

Hi,

 

The NIC Pairing feature is not present on the SMA at the moment. Here is the feature request for it: CSCzv93379

 

 

Do rate if helpful

 

Regards,

Kush

46
Views
5
Helpful
1
Replies