Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to configure snmp host in IPM?

Hi!!! I have CiscoWorks 2000 Rwan with IPM. I installed and configure IPM to send snmp traps when the treshold is excedeed. I can see on the graph that it is exceeded but I can not verify that it sending snmp traps.Where to view these traps and how to configure snmp reciver host?

Can I use CW2k syslog analyzer automated action to generate mail when get this trap?

THANKS FOR ANY HELP!!!!

Regards

Enes

2 REPLIES
New Member

Re: How to configure snmp host in IPM?

Hi,

As you've discovered, IPM can help configure

these traps:

http://www.cisco.com/univercd/cc/td/doc/product/rtrmgmt/ipmcw2k/cipm25/ug/ipmfaq.htm#62205

But, you'll need to specify a dedicated NMS

server to receive these traps. The following

documentation should prove to be useful:

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094aa5.shtml

http://www.cisco.com/en/US/tech/tk648/tk362/technologies_tech_note09186a0080094a05.shtml

You can use the appropriate "debug" command on

the router to confirm that traps are, in fact,

being sent.

The traps themselves are defined in the

CISCO-RTTMON-MIB.my and cannot interact

with the CW2000 syslog analyzer automated

action.

Thanks,

Roger

New Member

Re: How to configure snmp host in IPM?

THANKS!!

How can I view these traps that IPM send to my CW2K on my CW2K.

Where are the traps!

I see with debug that they are sent to my NMS (CW2K)

Is there any chance to send tese traps as syslog messages?

THANKS FOR HELP!!!

135
Views
0
Helpful
2
Replies
CreatePlease to create content