Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

https access to switch through vrf in 12.2(52)SE

I have no longer HTTPs access to the 3560 switch, after an upgrade to 12.2(52)SE.

The problem is obviously related to the fact that I am trying to connect to a switch IP address

that belongs to a dedicated "management" VRF management.  Debugging tcp on the switch

shows that it immediately sends TCP resets.

If I target the web browser to another switch IP address, which is in the global routing table, then the

router accepts the connection!

I had similar problems when accessing the switch via SSH.  This could be cured however,

by putting an access-class command under the VTY lines with the "vrf-also" command.

For the HTTPs access (needed for managing the switch with CNA) I have not found a solution

yet.  Any ideas?

NOTE: in the previous IOS  version (12.2(37)SE1), there was no problem for HTTPS access

within a VRF...

Thanks,

Patrick

Everyone's tags (3)
819
Views
0
Helpful
0
Replies