Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

IP SLA and Jitter OID > SNMP Manager

Hi,
I have an IP SLA jitter process configured on my router. See config below.
I have discovered the SLA Process via SNMP using a 3rd party SNMP product
but I need to know the OID I should query to collect the Jitter and Mos
Figures. RTT Latency seems to work fine but I am having problems with Jitter /MOS.   The config looks fine, sla output looks okay but my snmp manager still doesn't display any stats for Jitter/MOS.

I'm running c2800nm-entservicesk9-mz.124-7a.bin  on my router. Config and output below from show ip sla monitor stats/config is attached.

I know the RTTMON mib is involved but when I browsed the mib on cisco's website, I was a bit overwhelmed. The OID 1.3.6.1.4.1.9.9.42.1.3 but after that I appear to have 7 other sub-values..

Would Jitter be 1.3.6.1.4.1.9.9.42.1.3.5.1?

Not sure what Mos would be?

Any help appreciated?

Regards

Mary

***************************************************************************************************

Config is as follows:-
ip sla monitor 1
type jitter dest-ipaddr 10.80.100.54 dest-port 16384 codec g729a codec-size 30
tos 160 
verify-data
owner fpm
frequency 15
ip sla monitor schedule 1 life forever start-time now

killarney_PE3_crk#sh ip sla monitor configuration
SA Agent, Infrastructure Engine-II
Entry number: 1
Owner: fpm
Tag:
Type of operation to perform: jitter
Target address: 10.80.100.54
Source address: 0.0.0.0
Target port: 16384
Source port: 0
Operation timeout (milliseconds): 5000
Codec Type: g729a
Codec Number Of Packets: 1000
Codec Packet Size: 30
Codec Interval (milliseconds): 20
Advantage Factor: 0
Type Of Service parameters: 0xA0
Verify data: Yes
Vrf Name:
Control Packets: enabled
Operation frequency (seconds): 15
Next Scheduled Start Time: Start Time already passed
Group Scheduled : FALSE
Life (seconds): Forever
Entry Ageout (seconds): never
Recurring (Starting Everyday): FALSE
Status of entry (SNMP RowStatus): Active
Threshold (milliseconds): 5000
Number of statistic hours kept: 2
Number of statistic distribution buckets kept: 1
Statistic distribution interval (milliseconds): 20
Enhanced History:
killarney_PE3_crk#sh ip sla monitor statistics
Round trip time (RTT)   Index 1
        Latest RTT: 16 ms
Latest operation start time: 09:32:18.332 utc Fri May 7 2010
Latest operation return code: OK
RTT Values
        Number Of RTT: 1000
        RTT Min/Avg/Max: 16/16/27 ms
Latency one-way time milliseconds
        Number of one-way Samples: 1000
        Source to Destination one way Min/Avg/Max: 6/6/10 ms
        Destination to Source one way Min/Avg/Max: 9/10/19 ms
Jitter time milliseconds
        Number of Jitter Samples: 999
        Source to Destination Jitter Min/Avg/Max: 1/1/4 ms
        Destination to Source Jitter Min/Avg/Max: 1/1/9 ms
Packet Loss Values
        Loss Source to Destination: 0           Loss Destination to Source: 0
        Out Of Sequence: 0      Tail Drop: 0    Packet Late Arrival: 0
Voice Score Values
        Calculated Planning Impairment Factor (ICPIF): 11
MOS score: 4.06
Number of successes: 99
Number of failures: 0
Operation time to live: Forever

  • Security Management
1 REPLY
New Member

Re: IP SLA and Jitter OID > SNMP Manager

To get the MOS score i'm using this:

1.3.6.1.4.1.9.9.42.numberoftheoperation   and then you must divide it by 100

"ip sla monitor 1"  the operation number is 1

5285
Views
0
Helpful
1
Replies