We are trying to figure out exactly what route to take with the following scenario.
We would like to implement IP SLA to monitor latency. Setting this up is not an issue. When the latency goes above a certain threshold the router fires off an SNMP trap to our management system and we get alerted based on that. My issue is that I would like to run a trace route command to the IP that is being moitored by the specific IP SLA command. I am thinking that I would need to use Cisco EEM with even tracking for this and am just looking for a bit of verification. Any help would be greatly appreciated. Thanks in advance!
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...