is it possible to create VPN connection using one subnet?
I have branch connected to main office with fiber so now it connected with vlan but I want to configure IPsec for this I have to change the ip adress and add new one I mean I use one ip subnet so if I am configure IPSec I must use 2 subnet
I want to know is there any possibility without changing or using another subnet I reckon using one subnet for IPsec cause there have mobil users who come to main office without changing ip address my question is: may I use one subnet for IPSec connection or is there any possibility for this without adding another subnet
Re: is it possible to create VPN connection using one subnet?
Creating a VPN topology involves specifying the devices and the networks that make up the site-to-site VPN. You define the devices and their roles (such as hub, spoke, peer), the VPN interfaces that are the source and destination endpoints of the VPN tunnel, and the protected networks that will be secured by the tunnel. You can create hub-and-spoke, point-to-point, or full mesh topologies. When you create a VPN topology, you assign to it the IPsec technology with which a predefined set of policies is associated.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...