I am trying to use a VPN tunnel to allow a workstation to periodically appear on a real world IP address on the external side of a 3005. I have set up appropriate group and address pools. Once connected the client cannot see the internet nor can the client be seen from the external IP. ALLOW LAN ACCESS is turned off.
1) Has anyone ever done this before?
2) If so, do you have any ideas what could be wrong?
Not exactly sure what you configuration of the devices actually is so you might take a look at the following URL to see if there is a configuration example for what you are trying to do or contact Cisco over this issue. http://www.cisco.com/warp/public/707/index.shtml.
BenefitsDocumentationPrerequisiteImage Download LinksLimitationsSupported PlatformsLicense RequirementsTopologyStep-By-Step ConfigurationConfigure Virtual ServiceActivate the virtual service and configure guest IPsConfiguring UTD (Service Plane)Configurin...
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...