Trying to connect tunnel from two Linksys RV082's. Site A has Linksys behind 2600 and site B has linksys behind 1601. Site B linksys wan1 has internal ip address with cisco 1601 using static nat from public to internal. Is there a way to have Cisco 1601 pass public ip to Linksys without using NAT?
Network Address Translation (NAT) and IPSec might be needed together on a device when the same link is used for reaching the Internet as well as remote branches of the corporate network. While address translation of non IPSec-protected data is necessary, the IPSec protected data can be allowed through without address translation.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...