i have installed LMS and sucessfully integrated it with ACS 4.1 , yet when i check on the security settings i find the following message : "CiscoWorks System Identity User Configuation in ACS Not all privileges assigned " ok that is still not the problem .
my problem is that since that integration the RME device list is totally empty putting inconsideration that the DCR list exists and the devices listed there is assigned in the ACS
why don't these devices show in the RME device list can anyone help me in that issue??
First, LMS 2.6 and ACS 4.1 is not officially supported. You should either move to ACS 4.0, or upgrade to LMS 3.0 or higher.
The error about the System Identity User is quite severe. That user (as seen under Common Services > Security > System Identity Setup) must have access to all CiscoWorks tasks in ACS. This means you will need to create a custom role in ACS for all CiscoWorks applications. In LMS 3.0 and higher we automatically create a role called Super Admin which has access to all tasks. Once the roles are created, you need to go to the ACS group which contains your System Identity User, and make sure that use has the new role for each LMS application, and that the role is granted for all devices.
Once those steps are complete, restart ACS and CiscoWorks Daemon Manager. Assuming the user you use to log in to LMS has access to the required devices, you should now see devices in the device selector.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...