Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

logging source-interface in vrf

Hi together,

I have a vrf configuration on a cpe.

Now I wanna send all logging messages from loopback 10, and also from the vrf.

for commands like tftp, snmp, ntp the packets where send from the vrf with src ip of loopback 10.

Only for syslog it does not work.

any ideas, how to configure a vrf src interface for logging ?

actual config

int loopback 10

ip vrf red

ip address 1.1.1.253 255.255.255.255

# tftp packets where send from the vrf with src lo 10

ip tftp source-interface Loopback10

# logging packets where not sent from vrf, but with src lo 10

logging source-interface Loopback10

# snmp and ntp packets where send from vrf interface

snmp-server host 1.1.1.1 vrf red test

ntp server vrf red 1.1.1.1

thx

4 REPLIES
Red

Re: logging source-interface in vrf

Not sure about ntp, but for snmp traps, you may use the "snmp-server trap-source" command

New Member

Re: logging source-interface in vrf

snmp works fine, I have the problem for the "syslog messages"

New Member

Re: logging source-interface in vrf

Hi

I've reached a similar problem. Have you find a solution for the described problem?

thx

New Member

Re: logging source-interface in vrf

I found no solution, sorry

1251
Views
0
Helpful
4
Replies