MAC Filtering in wireless router with wireless access points.
I have a small network in my home building which is consist of Modem => Wireless Router => and 2 Wireless Access Points. Attached you can find my network diagram.
My question is about MAC filtering security. I configured MAC filtering security in my router where i can aad and delete MAC address easily but i can not get my access points setting page, when i try to open access point setting page it displayed main router setting page I checkd the network properties in computer and found it is taking the router getway address and due to this I am unable to access the setting page. Plz note access points are connected with router through network cable and my network is configured on DHCP.
My attention is to access the wireless access points setting page so that i can add and delete MAC address from any side. I appreciate if any one can expalin the procedure.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...