Is it possible to use more than one hub with a DMVPN WAN design for the purposes of resilience? Failing that, can two IP addresses for the hub be specified on each spoke?
This is only a small network comprised of about 10 spokes with ADSL and a hub with SDSL. The hub is going to be an 1841. Are we likely to run into resource [CPU, RAM] problems on the hub with that number of spokes? If not, how many spokes is an 1841 good for?
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...