Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

NAC Configuration

I have a wireless network that is seen by the VPN 3000 concentrator as one IP address. If I have one person logged onto the vpn and then a second person tries to logon the vpn, the first person gets booted off with a reason 427 error. On the event log of the Cisco VPN concentrator I see an error of NAC is disabled for peer. It seems I cannot have more than person connect to the vpn that is coming from the same IP address. How do I configure my VPN Concentrator to allow for more than one client to connect if they are behind one IP address?

1 REPLY
New Member

Re: NAC Configuration

This section describes the installation process that you perform to run ACS, which runs on a Windows 2000 Server, Windows 2003, or on a Cisco Secure ACS Solution Engine (ACS SE).

For detailed information on ACS installation, refer to the:

Installation Guide for Cisco Secure ACS for Windows Release 4.1

Installation Guide for Cisco Secure ACS Solution Engine Release 4.1

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_guide_chapter09186a0080731980.html

226
Views
0
Helpful
1
Replies
CreatePlease to create content