Need to monitor 7201 router without package for Ciscoworks
I'm a few months away from upgrading our Ciscoworks platform from LMS 2.6 to 3.1. However, I need to monitor a 7201 router and will not be able to to install the package for that system. I 'm getting snmp traps and get request, but the system is shown as unkown because I don't have the package installed. My support has run out until I get the 3.1 LMS software approved for purchase. Until then is it possible to monitor the 7201 router, I am receiving snmp message but Ciscowork doesn't seem to relate them correctly without the package being installed. I want to monitor the system for reachablity and sent a e-mail message out if it fails that test.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...