Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Netflow on only interface 7600 in output

Hi,

I would like use netflow on one or two interfaces. But i have a problem, because when i use netflow, i'm all reccords for all interfaces.

On the interface, that i want monitor, i use ip flow egress command

thanks your help.

1 REPLY

Re: Netflow on only interface 7600 in output

Hi,

Try checking the netflow status on the router (show ip flow interface), and disabled the netflow on the unwanted interfaces (no ip flow egress).

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124tcr/tnf_r/nfl_a1ht.htm#wp1415790

http://www.cisco.com/en/US/partner/products/ps6350/products_configuration_guide_chapter09186a00805eef7f.html

Rgds,

AK

144
Views
0
Helpful
1
Replies